Hydraulic Workshop Press

Frame is fabricated from IS-2062 graded rolled steel plates table and cutting beam are deeply reinforced and fines Hydraulic Workshop Press machines after stress reliving. The interlocked design put the direct support to frame. This frame is strain free and eliminates welds at load supports. Thus the accuracy of the Hydraulic Workshop Press machine is never disturbed.

The cylinder bodies are precisely made from forged steel material duly bored and fine honed for long sealing life. The piston rods are made From EN – 8 material having low carbon contents. The piston rod is hard chrome platted (0.200 micron).

The compact Blocks eliminate the leakage chances and also reduces the hydraulic pipes. This low Noise hydraulic system is placed on the rear side of Hydraulic Workshop Press machine, on top between two side plates. Pressure relief value is provided to safe guard the system and  Hydraulic Workshop Press machine from overload. The hydraulic system is driven by an electric motor of reputed brand and is coupled with a pump capable of generating more than the required pressure. Pressure gauge for system pressure, back pressure and holding pressure are providing on top of oil tank for quick reference.

The electrical control panel is located on the left hand side of the Hydraulic Workshop Press machine. It is assembled from the internationally reputed parts for consistent performance, reliability and availability, if need to be replaced. It is wire cleanly and labeled/ferruled properly as per the international practices to help easily locates any fault and replaces components conveniently.